The machine will hold the paper in place until the print data is sent to the machine. The side to be printed should be faced up. Once the machine has grasped the paper, let go. Using both hands, put one piece of paper in the manual feed slot until the front edge of the paper touches the paper feed roller. Using both hands, slide the manual feed paper guides to the width of the paper that you are going to use. Lift up the support flap to prevent paper from sliding off the face-down output tray, or remove each page as soon as it comes out of the machine. If you do not want to print from the manual feed slot, go to CASE B: Print from the Paper Tray (Tray 1). If you want to print from the manual feed slot, go to CASE A: Print from the Manual Feed Slot. Make sure there isn’t any remaining paper jammed under the print head, but be careful not to get ink on your clothes.The MANUAL FEED message appears when the manual feed slot is selected as the default paper source in the printer driver.Ĭheck the solution applicable for your case. You should first remove the jammed paper from the front, then from the back, and then check the inside of the printer. If the paper is jammed on both sides, follow the previous instructions step by step. Plug the printer back into the outlet and check if it’s working properly now.Take a look at the inside of the printer for any leftover paper.Close the cover and make sure you’ve done it correctly.Open the back cover of your Brother printer.If the paper gets stuck at the back, here’s what to do: When you’ve removed all the jammed paper from the printer, you can plug it back into the socket and check if the LCD has stopped displaying the error message.Check other places in the printer where paper could be jammed, such as under the scanner cover.If there’s jammed paper under the jam clear flap, raise it and remove the paper.Remove the paper tray from the printer.If the paper is stuck at the front, you should follow these steps: If you’re checking the inside of the printer and touching the print head, you should wait for it to cool down first. Before you start troubleshooting, unplug the printer from the power source.
0 kommentar(er)
